6 ft. 3/8 in plastic tubing
Hydro-Power PlusTM
water sight assembly
1 clamp band
Installation of the Canister
1. Check that you have received all the parts listed previously under Parts List. If not, please call your local dealer or call 785-421-5740. If there is no answer leave a message and the office will get back with you as soon as possible.
2. Make sure you have all the parts listed previously under Other Parts Needed.
3. Install the water sight assembly by screwing both elbows into the side of the unit. Locate the neoprene stopper and connect the chain ring around the top plastic elbow. Next slide the plastic tubing onto the top and bottom plastic elbows. You can follow the Water Sight Assembly Diagram in this manual.
4. Install the street ell into the side of your HF MaxTM canister.
5. Attach the plastic fuel output tube under the air cleaner element to the dirty side of the air filter in such a way to prevent the air filter from getting wet and to protect your engine.
6. Mount the canister unit firmly under the hood of the truck using the enclosed clamp band.
7. Follow the wiring Diagram in this manual to wire your canister to your vehicle.
8. Mount the amp gauge and toggle switch inside the cab of your vehicle in such a way that they would be visible and within reach while operating your vehicle.
9. Solder all electrical connections.
ALL ELECTRICAL CONNECTIONS MUST BE SOLDERED!
10.Use dielectric grease and lock washers on all other terminal connections. Bad wiring connections have been the biggest cause of low performance.
NOT FOLLOWING THESE INSTRUCTIONS CAN CAUSE POOR PERFORMANCE AND WILL POSSIBLY VOID THE WARRANTY!
Operation
Since pure water doesn't conduct electricity, to get the best results, a catalyst must be used. We are using Hydro-Power PlusTM (HPPTM) because in our test, it works the best. By controlling the amount of HPPTM in the water you can control the amperage draw. This unit is designed to operate on 15 to 25 amps, so that is the target amount of amp draw. Mix 1 level tablespoon of HPPTM in 1 cup of distilled water and add to the canister. Fill the canister to about the middle of the sight glass with distilled water. USING ANYTHING OTHER THAN DISTILLED
WATER WILL VOID THE WARRANTY. Do not overfill. This should be about the right amount for 15 to 25 amps, but different application voltages will effect this so each application will vary slightly. Too much HPPTM will cause too high of an amp draw and will result in tripping the breaker, causing higher than normal operating temperatures which can damage the unit. It will also create excessive steam. On some engines this will lower the performance of the unit and dramatically effect fuel savings. This unit will not reach full output or amp draw for about 20 to 30 minutes and when cold, the amp draw will be about half of when it is warmed up. Included is enough HPPTM to get started. The HPPTM does not leave the generator so very little should be required as you add water. If you mix about 1 teaspoon of HPPTM per gallon of water it should keep your amps fairly consistent.
Maintenance
Regular maintenance will greatly increase the life and efficiency of the HF MaxTM unit. The electrical connections on top of the generator should be checked daily or at each refill for tightness to insure a good connection and proper performance. Always use distilled water to reduce the amount of sediment between service intervals. If you have any questions about operation or installation call 785.421.8136 between 9am and 5pm central time and we will be glad to answer your questions. If we don't answer, leave a message and we will return your call as soon as possible. Thanks for your business and together we will beat the high cost of foreign oil dependency.
Questions or Comments
Call
Home Office 785.421.5740
Online
Mail
Advanced Energies, LLC
PO Box 25
Hill City, KS 67642
Or Contact your Local HFMaxTM Dealer
Limited Warranty
Advanced Energies, LLC makes every effort to assure that its energy saving products meet high quality and durability standards, by providing a 30 day money back guarantee. If you are dissatisfied for any reason, return the product with proof of purchase for a full refund of the purchase price. We also will provide a 90 day free replacement on any material or workmanship defect and a 12 month prorated warranty. USING ANY WATER OTHER THAN DISTILLED WATER WILL VOID THIS WARRANTY. Since using hydrogen as a fuel is still in the experimental stages, we are unable to control or test for all the possible side effects of burning hydrogen that may arise. Therefore the warranty does not apply to physical or mechanical damage due directly or indirectly, to use, misuse, abuse, negligence or accident, repairs or alterations outside our facilities or to lack of maintenance. We shall in no event be liable for death, injuries to persons or property or for incidental, contingent, special or consequential damages arising from the use of our product. Some states do not allow the exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you. To take advantage of this warranty, the product or part must be returned to us with transportation charges prepaid. Proof of purchase, date, and an explanation of the complaint must accompany the merchandise. If our inspection verifies the defect, we will either repair, or replace the product at our election or we may elect to refund the purchase price if we cannot readily and quickly provide you the replacement. We will return repaired products at our expense, but if we determine there is no defect, or that the defect resulted from causes not within the scope of our warranty, then you must bear the cost of storing and returning the product.
HydroFuel Maximizer, HFMax,
Hydro-Power Plus and it's logos are all
trademarks of
Advanced Energies, LLC
